คลิกเพื่อขยาย
BEHRINGER XENYX QX2442USB Analog Mixer
- ชนิด: มิกเซอร์อนาล็อก
- 24-input 4/2-bus mixer: with XENYX mic preamps and compressors, Klark Teknik multi-FX, a wireless option and USB audio interface
- 10 XENYX mic preamps: balanced XLR microphone inputs with switchable +48 V phantom power
- Extra mic inputs on stereo channels: channels 9/10 and 11/12 add an XLR microphone jack with phantom power
- Compressor on every mono channel: set the amount of compression with one COMP knob
🧾 ราคานี้เป็นราคากำหนดขายจากผู้ผลิต รวมภาษีมูลค่าเพิ่มแล้ว — ไม่มีการบวก VAT เพิ่มอีก
ราคาประเมินอุปกรณ์ ไม่รวมค่าติดตั้ง · ⚠️ กรุณารอยืนยันสต็อกสินค้าก่อนสั่งซื้อ
Ten mics, four subgroups, one engineer.
A full band on stage means a lot of channels and only two hands at the desk. The QX2442USB brings 10 XENYX mic preamps to that job. Every mono channel has a COMP knob to set how much compression it gets.
Many channels, a few faders
Press SUB 1-2 or SUB 3-4 on a channel to route it to the subgroups. SUB faders set the level at the SUB OUTPUT jacks. The LEFT/RIGHT buttons assign each subgroup to the main mix. When recording, pan hard left or right to send a channel to just one group output.
Monitors and effects for the stage
Press PRE when an aux feeds a stage monitor. The FX knob sends a channel to the Klark Teknik multi-FX processor, with hall, room, delay and modulation presets. Channels 9/10 and 11/12 add XLR mic inputs with phantom power. The wireless input takes a USB receiver for Behringer ULM wireless microphones. It accepts signals from 2 independent mics.
A computer on the same desk
USB carries stereo audio in and out at 48 kHz. Press USB/2-TR TO MAIN to bring computer playback into the main mix. The MODE button switches SOLO between Solo in Place and Pre-Fader Listen, which is preferred for setting gain.
Features
- 24-input 4/2-bus mixer: with XENYX mic preamps and compressors, Klark Teknik multi-FX, a wireless option and USB audio interface
- 10 XENYX mic preamps: balanced XLR microphone inputs with switchable +48 V phantom power
- Extra mic inputs on stereo channels: channels 9/10 and 11/12 add an XLR microphone jack with phantom power
- Compressor on every mono channel: set the amount of compression with one COMP knob
- 3-band EQ: high, mid and low controls, with a FREQ knob to select the frequency the MID knob adjusts
- 4 subgroups: SUB 1-2 and 3-4 with their own faders, assignable to the left and right main mix
- Klark Teknik multi-FX: presets include large halls, small rooms, delay/ambience and modulation
- Aux sends with PRE: AUX knobs adjust channel signal levels sent to AUX SEND jacks; press PRE when routing to a stage monitor
- Wireless input: takes a USB receiver and accepts signals from 2 independent Behringer ULM mics
- USB audio interface: stereo in and out at a 48 kHz sample rate
- USB/2-TR to main: one button routes USB and 2-track signals into the main mix
- Solo modes: the MODE button switches SOLO between Solo in Place and Pre-Fader Listen, preferred for gain setting
| Mic input type (XENYX mic preamp) | XLR connector, balanced, discrete input circuit |
|---|---|
| Mic E.I.N. (20 Hz to 20 kHz), 0 Ω source resistance | -134 dB / -136 dB A-weighted |
| Mic E.I.N. (20 Hz to 20 kHz), 50 Ω source resistance | -131 dB / -133 dB A-weighted |
| Mic E.I.N. (20 Hz to 20 kHz), 150 Ω source resistance | -129 dB / -131 dB A-weighted |
| Mic frequency response | <10 Hz to 150 kHz (-1 dB) |
| Inputs - Mic frequency response | <10 Hz to 200 kHz (-3 dB) |
| Mic gain range | +10 dB to +60 dB |
| Mic max. input level | +12 dBu @ +10 dB gain |
| Mic input impedance | 2 kΩ balanced |
| Mic distortion (THD+N) | 0.005% / 0.004% A-weighted |
| Phantom power | Switchable, +48 V |
| Mono line input type | 1/4" TRS connector, balanced |
| Mono line input impedance | 20 kΩ balanced, 10 kΩ unbalanced |
| Mono line gain range | -10 dB to +40 dB |
| Mono line max. input level | 30 dBu |
| Stereo input type | 4 x 1/4" TRS connector, balanced |
| Stereo input impedance | 20 kΩ balanced, 10 kΩ unbalanced |
| Stereo input gain range | -20 dB to +20 dB |
| Stereo input max. input level | +22 dBu |
| 2-track in type | RCA connector |
| 2-track in impedance | 10 kΩ |
| 2-track in max. input level | +22 dBu |
| AUX return type | 4 x 1/4" TRS connector, balanced |
| AUX return impedance | 20 kΩ balanced, 10 kΩ unbalanced |
| AUX return max. input level | +22 dBu |
| Microphone inputs (XENYX mic preamp) | 10 |
| Mic signal-to-noise ratio | 108 dB / 110 dB A-weighted (0 dBu In @ +22 dB gain) |
| AUX send type | 4 x 1/4" TRS connector, balanced |
| AUX send impedance | 120 Ω |
| AUX send max. output level | +22 dBu |
| Main output type | XLR connector, balanced |
| Main output impedance | 240 Ω balanced, 120 Ω unbalanced |
| Main output max. output level | +28 dBu |
| Control room output type | 1/4" TRS connector, balanced |
| Control room output impedance | 120 Ω |
| Control room output max. output level | +22 dBu |
| Phones output type | 1/4" TRS connector, unbalanced |
| Phones output impedance | 25 Ω |
| Phones output max. output level | +21 dBu / 150 Ω (+25 dBm) |
| 2-track out type | RCA connector |
| 2-track out impedance | 1 kΩ |
| 2-track out max. output level | +22 dBu |
| Frequency response, mic in to main out | <10 Hz to 160 kHz ±3 dB |
| Main mix noise, main mix and channel fader @ -∞ | -102 dB / -105 dB A-weighted |
| Main mix noise, main mix @ 0 dB, channel fader @ -∞ | -85 dB / -88 dB A-weighted |
| Main mix noise, main mix and channel fader @ 0 dB | -77 dB / -79 dB A-weighted |
| 3-band semi-parametric EQ, low | 80 Hz / ±15 dB |
| 3-band semi-parametric EQ, mid | Variable 100 Hz to 8 kHz / ±15 dB |
| 3-band semi-parametric EQ, high | 12 kHz / ±15 dB |
| 4-band fixed EQ, low | 80 Hz / ±15 dB |
| 4-band fixed EQ, high | 12 kHz / ±15 dB |
| DSP type | Klark Teknik |
| DSP converter | 24-bit Sigma-Delta |
| DSP converter oversampling | 64/128-times oversampling |
| DSP sampling rate | 40 kHz |
| Channel insert type | 1/4" TRS connector, unbalanced |
| Channel insert max. input level | +22 dBu |
| USB connector | Type B |
| USB converter | 16-bit |
| USB sample rate | 48 kHz |
| Wireless input (USB dongle) | Accepts signals from 2 independent Behringer ULM mics |
| Mains voltage | 100 to 240 V~, 50/60 Hz |
| Mains connector | Standard IEC receptacle |
| Ref. Code | TCR-FL3CMY |
คู่มือ (Manual)
อุปกรณ์ที่ใช้งานร่วมกัน
เพิ่มความสมบูรณ์ให้ระบบ — กด “เพิ่มลงใบเสนอราคา” ได้ทันที
