คลิกเพื่อขยาย
BEHRINGER XENYX X1204USB Analog Mixer
- ชนิด: มิกเซอร์อนาล็อก
- Mic inputs: balanced XLR microphone inputs with switchable +48 V phantom power
- One-knob compressor: each mono channel has a compressor adjusted with its COMP knob
- 3-band EQ: boost or cut up to 15 dB at 80 Hz, 2.5 kHz and 12 kHz
- 24-bit multi-FX processor: reverb, chorus, flanger, delay and combination effects built in
🧾 ราคานี้เป็นราคากำหนดขายจากผู้ผลิต รวมภาษีมูลค่าเพิ่มแล้ว — ไม่มีการบวก VAT เพิ่มอีก
ราคาประเมินอุปกรณ์ ไม่รวมค่าติดตั้ง · ⚠️ กรุณารอยืนยันสต็อกสินค้าก่อนสั่งซื้อ
The band, the voice and the recording, on one desk.
Half an hour before the service. The band wants to hear itself, and the speaker's voice has to reach the back row. Then someone asks you to record it for those who could not come. The X1204USB handles the room, the monitors and the recording from one desk.
A compressor on every mono channel
Plug a condenser microphone into a mono channel's XLR input and switch on +48 V phantom power. Turn up COMP, and a voice that swings between quiet and loud evens out. Three British EQ bands boost or cut by up to 15 dB. A 75 Hz low cut clears rumble from the stage.
Monitors the band can hear
With aux 1 pre-fader, the monitor mix stays put while you ride the faders for the room. The 24-bit effects processor adds reverb, chorus, flanger or delay. FX TO MON blends the same effect into the monitors, so the singer hears it too.
Keep the service for everyone who missed it
Over USB, the main mix goes to your computer and stereo playback comes back. No driver is required. Need four tracks? Send the ALT 3-4 and main outputs to a multitrack recorder.
Features
- Mic inputs: balanced XLR microphone inputs with switchable +48 V phantom power
- One-knob compressor: each mono channel has a compressor adjusted with its COMP knob
- 3-band EQ: boost or cut up to 15 dB at 80 Hz, 2.5 kHz and 12 kHz
- 24-bit multi-FX processor: reverb, chorus, flanger, delay and combination effects built in
- Aux and FX sends: aux send 1 can switch pre-fader; the FX send routes directly to the built-in effects processor
- Channel solo: monitor a channel signal without affecting the main output
- Stereo aux return 1: connectors can also be used as additional line inputs
- Stereo audio I/O: stereo input and output at 48 kHz, with no drivers required
- Power requirements: 100 to 240 V at 50/60 Hz, with 40 W consumption
| Mic input type | XLR, electronically balanced, discrete input circuit |
|---|---|
| Mic input frequency response | <10 Hz to 150 kHz ((-1 dB)) |
| Inputs - Mic input frequency response | <10 Hz to 200 kHz ((-3 dB)) |
| Mic input gain range | +10 to +60 dB |
| Mic input max. input level | +12 dBu @ +10 dB gain |
| Mic input impedance | approx. 2.6 kΩ balanced |
| Mic input distortion (THD + N) | 0.005% / 0.004% A-weighted |
| Line input type | ¼" TRS connector electronically balanced |
| Line input impedance | approx. 20 kΩ balanced, approx. 10 kΩ unbalanced |
| Line input gain range | -10 to +40 dB |
| Line input max. input level | 30 dBu |
| Frequency response, mic input to main out | <10 Hz to 90 kHz (+0 dB / -1 dB) |
| Inputs - Frequency response, mic input to main out | <10 Hz to 160 kHz (+0 dB / -3 dB) |
| Stereo input max. input level | +22 dBu |
| Stereo input gain range | -20 dB to +20 dB |
| CD/Tape in type | RCA connector |
| CD/Tape in impedance | 10 k Ohms |
| CD/Tape in max. input level | +22 dBu |
| Stereo aux returns type | ¼" TRS connector, electronically balanced |
| Stereo aux returns impedance | approx. 20 kΩ bal. / 10 kΩ unbal. |
| Stereo aux returns max. input level | +22 dBu |
| Aux sends type | ¼" TS connector, unbalanced |
| Aux sends impedance | approx. 120 Ω |
| Aux sends max. output level | +22 dBu |
| Main outputs type | XLR, electronically balanced |
| Main outputs max. output level | +28 dBu |
| Control room outputs type | ¼" TS connector, unbal. |
| Control room outputs impedance | approx. 120 Ω |
| Control room outputs max. output level | +22 dBu |
| Headphones output type | ¼" TRS connector, unbalanced |
| Headphones output max. output level | +19 dBu / 150 Ω (+25 dBm) |
| CD/Tape out type | RCA connector |
| CD/Tape out impedance | 1 k Ohms |
| CD/Tape out max. output level | +22 dBu |
| EQ mono channels: low | 80 Hz / ±15 dB |
| EQ mono channels: mid | 2.5 kHz / ±15 dB |
| EQ mono channels: high | 12 kHz / ±15 dB |
| EQ stereo channels: low | 80 Hz / ±15 dB |
| EQ stereo channels: mid | 2.5 kHz / ±15 dB |
| EQ stereo channels: high | 12 kHz / ±15 dB |
| DSP converter | 24-bit Sigma-Delta, 64/128-times oversampling |
| DSP sampling rate | 40 kHz |
| USB audio | Stereo In/Out |
| USB connector | TypeB |
| USB converter | 16-bit |
| USB sample rate | 48 kHz |
| Mains voltage | 100 to 240 V~, 50/60 Hz |
| Mains connection | Standard IEC receptacle |
| Ref. Code | TCR-2NZD42 |
อุปกรณ์ที่ใช้งานร่วมกัน
เพิ่มความสมบูรณ์ให้ระบบ — กด “เพิ่มลงใบเสนอราคา” ได้ทันที
